Multitech MTCBA-H3-EN3-P1 User's Guide download pdf (Page 9)

Chapter 1 – Introduction and Description

9 Multi-Tech Systems, Inc. MultiModem rCell User Guide

● Keep the device on the opposite the side of the body from the pacemaker to add extra distance between the

pacemaker and the device.

● Avoid placing a turned-on device next to the pacemaker (for example, don’t carry the device in a shirt or

jacket pocket directly over the pacemaker).

Front Panel

The front panel contains nine LEDs and the SIM card holder. For details on inserting a SIM card, refer to Insert the

SIM Card into Holder.

LED

Indicator

Description

Power

Lit when there is power.

Status

Solid light when the rCell boots up, saves the configuration, restarts, or updates the firmware.

Blinks when the router is ready.

LNK

Link. Blinks when there is transmit and receive activity on the Ethernet link.

Shows a steady light when there is a valid Ethernet connection.

SPD

Speed. Lit when the Ethernet link is at 100 Mbps. If it is not lit, the Ethernet link is at 10 Mbps.

Carrier Detect. Lit when data connection has been established.

Link Status.

Permanently On: Powered on and connected, but not transmitting or receiving.

Slow flashing state (5 Seconds) Powered on searching for a connection.

Fast flashing state (0.3 seconds) Transmitting and receiving.

Signal

ALL OFF: Unit is off, not registered on network, or extremely weak signal (0 < = RSSI < 6).

1 Bar ON: Very weak signal (7 < = RSSI <14)

1 Bar and 2 Bar: Weak signal (15 < = RSSI <23)

1 Bar, 2 Bar, and 3 Bar ON: Good signal (24 <= RSSI > = 31)

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 70 71

No comments

Multitech MTCBA-H3-EN3-P1 User's Guide Page 9