Multitech MTCBA-H3-EN3-P1 User's Guide download pdf (Page 30)

Chapter 3 – Using the Web Management Software

Multi-Tech Systems, Inc. MultiModem rCell User Guide 30

Time Zone Configuration

Time Zone: Enter your time zone. Default = UTC (Universal Coordinated Time, Universal Time). See

the following Web site for Time Zone information:

http://wwp.greenwichmeantime.com/info/current-time.htm

Time Zone Offset: Enter +/- hh:mm. Default = +00:00. Offset is the amount of time varying from the

standard time of a Time Zone.

Daylight Configuration

Daylight Saving: Enables/disables Daylight Saving mode. The default is Enable.

Daylight Saving Offset: Set the offset to use during Daylight Saving mode. Default is +60 minutes. Enter the

time in + / - minutes.

Daylight Saving Start Time

Start Ordinal: Set the start ordinal to use during Daylight Saving mode. Options are

first/second/third/fourth/last. Default is second. Daylight Saving time usually starts at

the same time on the same day of the week in the same month every year. Each day of

the week occurs four or five times a month. Therefore, you will be selecting the week in

which daylight saving time starts: the first, second, third, fourth or the last of the

month.

Start Month: Set the start month to use during Daylight Saving mode. Default is March.

Start Day: Set the start weekday to use during Daylight Saving mode. Default is Sunday.

Start Time: Set the start time to use during Daylight Saving mode. Default is 02:00 (hh:mm).

Daylight Saving End Time

End Ordinal: Set the end ordinal to use during Daylight Saving mode. Select the week in which

daylight saving time ends. Options are first/second/third/fourth/last. Default is first.

End Month: Set the end month to use during Daylight Saving mode. Default is November.

End Day: Set the end weekday to use during Daylight Saving mode. Default is Sunday.

End Time: Set the end time to use during Daylight Saving mode. Default is 02:00 (hh:mm).

IP Setup > Static Routes

Routing information is used by every computer connected to a network to identify whether it is sending a data

packet directly to the firewall or passing it on to another network. The options to Delete or Edit a route after it has

been defined and added are available by using the table at the bottom of the screen.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 70 71

No comments

Multitech MTCBA-H3-EN3-P1 User's Guide Page 30