Multitech MTCBA-H3-EN3-P1 User's Guide download pdf (Page 34)

Chapter 3 – Using the Web Management Software

Multi-Tech Systems, Inc. MultiModem rCell User Guide 34

 For EVDO models, the Dial Number is #777

Dial Prefix: Set the modem dial prefix. The default is ATDT.

Connect String: Set the modem Connect String. The default is CONNECT.

APN: Enter the APN (Access Point Name). For more information on APN, refer to Access Point

Names.

Init String 1-4: Configure the modem init strings. You can set up to 4 modem initialization strings.

Baud Rate: Baud Rate only displays on certain models and is set at 230.4K, by default. The default

setting is set for maximum performance.

PPP > Wakeup-on-Call

The Wakeup-on-Call feature allows the router to wake up and initiate a connection when there is an incoming call

or LAN activity. If you desired some security with this feature, you can set up the router to wake up based on

Caller ID or SMS instead of allowing all incoming calls to wakeup the router. Dial-on-Demand in the IP Setup menu

must be enabled for these settings to have any affect. The Wakeup-on-Call feature will reduce the cost incurred

when a router is online and available 24/7.

Note: When provisioning this feature, you must allow incoming calls, SMS capability, and/or caller-id.

Wakeup-on-Call Configuration

Wakeup on Call: Enable/disable the Wakeup-on-Call feature. The default is Disable. Wakeup-on-Call

occurs when a ring or caller ID is detected. This will trigger the router to reconnect after

the ‘Time Delay’ expires.

Time Delay: Enter the amount of time that you want to pass between the reception of a call and the

initiation of the Wakeup-on-Call connection. A time delay is needed to make sure that

the incoming call has ended before the connection is initiated. The default is 10

seconds.

Dial-on-Demand

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 70 71

No comments

Multitech MTCBA-H3-EN3-P1 User's Guide Page 34