Multitech MTCBA-H3-EN3-P1 User's Guide download pdf (Page 21)

Chapter 2 – Installation

21 Multi-Tech Systems, Inc. MultiModem rCell User Guide

 In the command window, type telnet 192.168.2.1 5000

 At the Login prompt, type the default user name: admin (all lower-case). Press ENTER

 At the Password prompt, type the default password: admin (all lower-case). Press ENTER

2. In the command window, type AT+CSQ . The router responds with the received signal strength (rssi).

Signal Strength – RSSI

10 – 31

Sufficient

0 – 9

Weak or Insufficient

Insufficient

Once you have a good signal for where you are going to place the router, either refer back to Optional

Mounting in this Chapter if you are permanently mounting your router or continue with Account Activation

for Wireless Devices.

Account Activation for Wireless Devices

Please refer to Multi-Tech’s Cellular Activation Web site at http://www.multitech.com/activation.go for

information on activating your cellular modem.

Note: If you need remote access to your MultiModem over the Internet for remote configuration, you need to

ensure that your wireless network provider has provisioned mobile terminated data and fixed or

dynamic public IP address in which they can configure the network to redirect any incoming connection

to that predefined IP.

Resetting the Router

To reset the router:

● Hold the Reset button in until the Status Light goes out. Then, release it.

This also sets the username and password back to admin and admin and the IP address to the default,

192.168.2.1.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 70 71

No comments

Multitech MTCBA-H3-EN3-P1 User's Guide Page 21