Chapter 3 – Using the Web Management Software
37 Multi-Tech Systems, Inc. MultiModem rCell User Guide
● All Init Strings should be empty.
Caller ID Configuration
● Enter the string RING to the Caller ID list.
● Click Add to save the string to the Caller ID list.
3. Click Save & Restart to save all the settings and reboot.
Example 3 – Set Up the Ethernet Router to Activate on Matching Caller IDs Only:
1. On the PPP > PPP Configuration screen, set up the following parameters and click Submit.
PPP General
● Make sure that PPP is enabled.
● Make sure Dial-on-Demand is enabled.
● Set the Idle Time Out to the number of seconds you desire.
Authentication
● Your wireless service provider may require you to have a separate PPP username and password. If so,
enter them here.
Note: If a username and password are required, your wireless provider would have given them to you when
you activated your account.
Modem Configuration
● Make sure your Dial Number is entered correctly, for HSPA models, the Dial Number is *99***1#
2. On the PPP > Wakeup-on-Call screen, set up the following parameters and click Submit.
Wakeup-on-Call Configuration
● Select Enable for Wakeup-on-Call.
● Set the Time Delay. You can use the 10 second default.
● Enter the Init Strings, Set Wakeup Init String 1 by entering AT+CLIP=1 for HSPA models only.
Caller ID Configuration
● Enter a caller’s ID that you want added to the Caller ID list.
● Click Add to save each Caller ID as it is entered to the Caller ID list.
3. Click Save & Restart to save all the settings and reboot.
Comments to this Manuals