Multitech MTCMR-H User's Guide download pdf (Page 56)

Chapter 3 – Supported GSM/WCDMA AT Commands

High Speed HSPA-H4 AT Commands Reference Guide (Document S000483A) 56

E Echo

Description: This command is used to determine whether or not the modem echoes characters received

by an external application (DTE).

Syntax:

Command Responses

Action Command:

ATE<n>

No Read and Test Commands

Values: <n> Echo Activation Parameter

0 Characters are not echoed. Default value if <n> is omitted.

1 Characters are echoed

Parameter Storage: The <n> parameter is stored in EEPROM using AT&W.

Examples:

Command Responses

ATE0

Note: Characters are not echoed

Note: Done

ATE1

Note: Characters are echoed

Note: Done

H Disconnect Existing Connections

Description: The ATH (or ATH0) command disconnects the remote user. In the case of multiple calls, all

calls are released (active, on-hold and waiting calls).

The specific ATH1 command disconnects the current outgoing call, only in dialing or alerting

state (i.e., ATH1 can be used only after the ATD command and before its terminal response

(OK, NO CARRIER, ...) It can be useful in the case of multiple calls.

Syntax:

Command Responses

Action Command:

ATH<n>

No Read and Test Commands

Values: <n> Disconnection Type

0 Ask for disconnection (default value)

1 Ask for outgoing call disconnection

Examples:

Command Responses

ATH

Note: Ask for disconnection

Note: Every call, if any, is released

ATH1

Note: Ask for outgoing call disconnection

Note: Outgoing call, if any, is released

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 146 147

Comments to this Manuals

No comments

Multitech MTCMR-H User's Guide Page 56

Comments to this Manuals

Related products and manuals for Networking Multitech MTCMR-H