Multitech MTCMR-H User's Guide download pdf (Page 60)

Chapter 3 – Supported GSM/WCDMA AT Commands

High Speed HSPA-H4 AT Commands Reference Guide (Document S000483A) 60

S10 Automatic Disconnect Delay

Description: This command defines the duration of received-line-signal loss that the DCE tolerates. If the

duration is exceeded, the DCE disconnects. The value is not persistent.

Syntax: Command syntax: ATS10=<value>

Command Possible Responses

ATS10=10 OK

Values: <value> Value in tenths of a second

1 – 254 Default value is 14 (or 1.4 seconds)

255 Ignore received-line-signal loss; do not disconnect

T Select Tone Dialing

Description: This command is used to select tone dialing. Not relevant to CDMA data services; “T” is not

sent in dial string.

Syntax: Command syntax: ATT

Command Possible Responses

ATT

Note: select tone dialing.

Note: Command is valid

V Set Result Code Format Mode

Description: This command determines whether or not the Data Circuit Equipment (DCE) response

format uses header characters <CR><LF> and whether the result codes are provided as

numeric or verbose.

Syntax:

Command Responses

Action Command:

ATV<n>

No Read and Test Commands

Values: <n> Format Control Parameter

Information Responses Result Code

0 <text><CR><LF> <numeric code><CR>

1 <CR><LF> <CR><LF> Default

Parameter Storage: The <n> parameter is stored in EEPROM using AT&W. The default value can be

restored using AT&F.

Examples:

Command Responses

ATV0

Note: DCE transmits limited headers

and trailers and numeric result codes

Note: Command is valid (0 means OK)

ATV1

Note: DCE transmits full headers and

trailers and verbose response text

Note: Command valid

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 146 147

Comments to this Manuals

No comments

Multitech MTCMR-H User's Guide Page 60

Comments to this Manuals

Related products and manuals for Networking Multitech MTCMR-H