Multitech MTCMR-H User's Guide download pdf (Page 59)

Chapter 3 – Supported GSM/WCDMA AT Commands

High Speed HSPA-H4 AT Commands Reference Guide (Document S000483A) 59

S6 Set Pause Before Blind Dialing

Description: No effect for GSM.

Syntax:

Read Command: ATS6?

Read Response: <n>

Write Command: ATS6=<n>

Write Response: OK

ERROR

Parameter Description:

<n>

002 – 10 Default is 002

S7 Set Number of Seconds to Wait for Connection

Completion

Description: This command defines the maximum time allowed between completion of dialing and the

connection being established. If this time is exceeded, then the connection is aborted. The

value is not persistent.

Syntax: Command syntax: ATS7=<value>

Command Possible Responses

ATS7=100 OK

Values: <value> Timeout in seconds

1 – 255 Default value is 50

S8 Set Number of Seconds to Wait When Comma Dial

Modifier Is Used

Description: This command specifies the amount of time, in seconds, that the DCE shall pause, during

signaling of call addressing information to the network (dialing), when a “,” (comma) dial

modifier is encountered in a dial string. No effect for GSM.

Syntax:

Read Command: ATS8?

Read Response: <n>

Write Command: ATS8=<n>

Write Response: OK

ERROR

Parameter Description:

<n>

0 DCE does not pause when “,” encountered in dial string.

1...255 Default = 2. Number of seconds to pause

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 146 147

No comments

Multitech MTCMR-H User's Guide Page 59