Multitech MultiVOIP 800 MVP800 User's Guide download pdf (Page 49)

Chapter 3 - Software Loading and Configuration

Remote Site Administrator

The following steps are for MultiVOIP 400/800 H.323 endpoints. For non-MultiVOIP 400/800 H.323

endpoints, refer to the appropriate installation documentation.

3. Unpack your MultiVOIP 400/800.

4. Connect one end of the power supply to a live AC outlet and connect the other end to the Power

connection on your MultiVOIP 400/800 (See Figure 3-1).

FXSE&M

FXO

PSTN

Ethernet Connection

Power Connection

10BASET

ETHERNET

POWER

Voice/Fax Channel

Connections

E&M

FXO

FXS

Figure 3-1. Remote Site Cable Connection

5. Connect a network cable to the ETHERNET 10Base-T (RJ-45) connector on the back of your

MultiVOIP 400/800.

6. If you are connecting a station device (e.g., analog telephone, fax machine, or Key Telephone

System (KTS) to your MultiVOIP 400/800, connect the smaller end of a special adapter cable

(supplied) to the Voice/Fax Channel 1 FXS connector on the back of the MultiVOIP 400/800 and

the other end to the station device.

If you are connecting a PBX extension to your MultiVOIP 400/800, connect the smaller end of a

special adapter cable (supplied) to the Voice/Fax Channel 1 FXO connector on the back of the

MultiVOIP 400/800 and the other end to the PBX extension.

If you are connecting an E&M trunk from a telephone switch to your MultiVOIP 400/800, connect

one end of an RJ-45 phone cord to the Voice/Fax Channel 1 E&M connector on the back of the

unit and the other end to the trunk phone jack.

If you are connecting to an E&M trunk, you need to ensure that the E&M trunk jumper is in the

correct position for the E&M type trunk. The default E&M jumper position is E&M type 2. To

change the E&M jumper position, perform the E&M jumper block positioning procedure.

7. Repeat the above step to connect the remaining telephone equipment to each Voice/Fax

Channel on your MultiVOIP.

8. Turn on power to the MultiVOIP 400/800 by placing the ON/OFF switch on the back panel to the

ON position. Wait for the BOOT LED on the MultiVOIP 400/800 to go OFF before proceeding.

This may take a couple of minutes.

9. At this time your VOIP network should be fully operational. Dial one of the sites in your network

using the dialing directory supplied by your network administrator.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 110 111

Comments to this Manuals

No comments

Multitech MultiVOIP 800 MVP800 User's Guide Page 49

Comments to this Manuals

Related products and manuals for Networking Multitech MultiVOIP 800 MVP800