Multitech MultiVOIP 800 MVP800 User's Guide download pdf (Page 21)

Chapter 2 - Installation

E&M Jumper Block Positioning Procedure

A jumper block exists for each voice/fax channel. The jumper block is to the right of each set of

channel jacks. The jumper block contains 8-pairs of pins. The jumper plug fits over three pairs of

pins on the jumper block. The E&M type number is labeled on the pc board. The jumper plug needs

to be centered on the E&M type number. Perform the following procedure to change E&M jumper

position.

1. Ensure that power is removed from the MultiVOIP

2. Remove the front panel by loosening the two Phillips quarter turn screws.

3. Slide the top cover back off the chassis to expose the rear panel.

4. To change a jumper position, lift the jumper plug up off the jumper block and move to the new

position, ensuring that the center jumper is centered on the E&M type number.

2 (Default)

1,3

Figure 2-3. E&M Jumper Block

5. Change the jumper position for each voice/fax channel that is connecting to an E&M trunk that is

not a type 2. If you have two voice/fax channel boards in your unit and you need to change the

jumpers on the second board, remove the six screws from the top board and disconnect the

ribbon cable from the top board.

6. Slide the top cover back on to the chassis.

7. Replace the front panel and secure it by tightening the two Phillips quarter turn screws.

8. Return to the Cabling Procedure section.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 110 111

No comments

Multitech MultiVOIP 800 MVP800 User's Guide Page 21