Multitech MULTIVOIP MVP-810ST User's Guide download pdf (Page 41)

MultiVOIP FX Quick Start Guide Connectivity Test

Connectivity Test

The procedures “Phone/IP Starter Configuration” and “Phonebook Starter Configuration” must be

completed before you can do this procedure.

1. These connections must be made:

 MultiVOIP to local phone station

–OR--

MultiVOIP to extension of key phone

system

 MultiVOIP to command PC

 MultiVOIP to Internet

2. Inbound Phonebook and Outbound Phonebook must both be set up with at least one entry in each.

These entries must allow for connection between two voip units.

3. Console messages must be enabled. (If this has not been done already, go, in the MultiVOIP GUI, to

Configuration | Logs and select the “Console Messages” checkbox.

4. Make sure that the COM port connection is free so that the HyperTerminal program can use it.

5. Open the HyperTerminal program.

6. Use HyperTerminal to receive and record console messages from the MultiVOIP unit. To do so, set up

HyperTerminal as follows (setup shown is for Windows NT4; details will differ slightly in other MS

operating systems):

 In the upper toolbar of the HyperTerminal screen, click on the Properties button.

 In the “Connect To” tab of the Connection Properties dialog box, click on the Configure

button.

 In the next dialog box, on the “General” tab, set “Maximum Speed” to 115200 bps.

 On the “Connection” tab, set connection preferences to:

Data bits: 8

Parity: none

Stop bits: 1

 Click OK twice to exit settings dialog boxes.

7. Make VOIP call on a local phone line accessing PSTN directly or through key system..

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 192 193

No comments

Multitech MULTIVOIP MVP-810ST User's Guide Page 41