Multitech MULTIVOIP MVP-810ST User's Guide Page 81

  • Download
  • Add to my manuals
  • Print
  • Page
    / 193
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 80
MultiVOIP FX User Guide Technical Configuration
81
FXS Loop Start Interface: Parameter Definitions (cont’d)
Field Name Values Description
Caller ID fields
Enable (cont’d) Y/N
In general, the forms of the
‘Caller Name’ and ‘Caller
Phone Number’ differ
depending on the IP
transmission protocol used
(H.323, SIP, or SPP) and upon
entries in the phonebook
screens of the remote (CID
generating) voip unit. For
MVPFX2 units, only the SIP-
related Caller ID options are
available. The CID Name and
Number appearing on the
phone at the terminating FXS
end will come either from a
central office switch (showing a
PSTN phone number), or the
phonebook of the remote (CID
sending) voip unit.
Dialing Options fields
Regeneration Pulse, DTMF Indicates which type of dialing
must be regenerated, either
pulses or DTMF. For MVPFX2
units, DTMF is always used.
Inter Digit
Timer
1 - 10 seconds This is the length of time that
the MultiVOIP will wait
between digits. When the time
expires, the MultiVOIP will
look in the outbound
phonebook for the number
entered and place the call
accordingly.
Default = 2.
Inter Digit
Regeneration
Timer
in milliseconds
The length of time between the
outputting of DTMF digits.
Default = 100 ms.
The Caller ID feature has dependencies on both the telco central office and the MultiVOIP phone book. See
the diagram series after the FXO Parameters section below.
Page view 80
1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 192 193

Comments to this Manuals

No comments