Multitech MULTIVOIP MVP-810ST User's Guide download pdf (Page 28)

Phone/IP Starter Config. MultiVOIP FX Quick Start Guide

Phone/IP Starter Configuration

Full details here:

MVPFX2-2

MVPFX2-4

MVPFX2-8

Technical Configuration chapter

in User Guide

1. Open a browser and go to the IP Address of the MVPFX2 unit. In the sidebar menu click Configuration.

2. Go to Configuration | IP. Enter or alter any IP Parameters, as needed. Click OK.

3. Go to Configuration | Voice/Fax. Select Coder | “Automatic.” At the right-hand side of the dialog box,

click OK. If you know any specific parameter values that will apply to your system, enter them. Click

Copy Channel. Select Copy to All. Click Copy. At main Voice/Fax Parameters screen, click OK to exit

from the dialog box.

4. Enter telephone system information. Go to Configuration | Interface. Enter parameters obtained from

phone company or PBX administrator. Click OK.

5. Go to Configuration | Regional Parameters. Select the Country/Region that fits your situation. Click

OK and confirm. Click OK to exit from the dialog box.

6. Go to Configuration | Logs/Traces.

Select “Enable Console Messages.” Click OK.

To do logging with a SysLog client program, click on “SysLog Server – Enable” in the Logs/Traces screen.

To implement this function, you must install a SysLog client program. For more info, see the “SysLog

Server Functions” section of the Operation & Maintenance chapter of the

User Guide.

7. Go to Save &Apply. Click OK. This will save the parameter values that you have just entered.

The MultiVOIP’s “BOOT” LED will light up while the configuration file is being saved and loaded into

the MultiVOIP. Don’t do anything to the MultiVOIP until the “BOOT “LED is off (a loss of power at this

point could cause the MultiVOIP unit to lose the configuration settings you have made).

END OF PROCEDURE.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 192 193

No comments

Multitech MULTIVOIP MVP-810ST User's Guide Page 28