Multitech MULTIVOIP MVP-810ST User's Guide download pdf (Page 122)

100

101

Technical Configuration (T1/E1) MultiVOIP User Guide

122

Configuring the Digital T1/E1 MultiVOIP

There are two ways in which the MultiVOIP must be configured before

operation: technical configuration and phonebook configuration.

Technical Configuration. First, the MultiVOIP must be configured to

operate with technical parameter settings that will match the

equipment with which it interfaces. There are seven types of technical

parameters that must be set.

These technical parameters pertain to

(1) its operation in an IP network,

(2) its operation with T1/E1 telephony equipment,

(3) its transmission of voice and fax messages,

(4) its interaction with SNMP (Simple Network Management Protocol)

network management software (MultiVoipManager),

(5) certain telephony attributes that are common to particular nations or

regions,

(6) its operation with a mail server on the same IP network (per SMTP

parameters) such that log reports about VoIP telephone call traffic can

be sent to the administrator by email,

(7) implementing some common premium telephony features (Call

Transfer, Call Hold, Call Waiting, Call ID – “Supplementary Services”),

and

(8) selecting the method by which log reports will be made accessible.

The process of specifying values for the various parameters in these

seven categories is what we call “technical configuration” and it is

described in this chapter.

Phonebook Configuration. The second type of configuration that is

required for the MultiVOIP pertains to the phone number dialing

sequences that it will receive and transmit when handling calls. Both

the PBX/telephony equipment and the other VOIP devices that the

MultiVOIP unit interacts with will affect dialing patterns. We call this

“Phonebook Configuration,” and it is described in Chapter 7: T1

Phonebook Configuration and Chapter 8: E1 Phonebook Configuration of this

manual. Chapter 2, the Quick Start Instructions, presents additional

examples relevant to the T1/E1 voips.

Local/Remote Configuration. The MultiVOIP must be configured

locally at first (to establish an IP address for the MultiVOIP unit). But

changes to this initial configuration can be done either locally or

remotely.

Local configuration is done through a connection between the

“Command” port of the MultiVOIP and the COM port of the computer;

the MultiVOIP configuration program is used.

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 558 559

Comments to this Manuals

No comments

Multitech MULTIVOIP MVP-810ST User's Guide Page 122

Comments to this Manuals

Related products and manuals for Networking Multitech MULTIVOIP MVP-810ST