Multitech MULTIVOIP MVP-810ST User's Guide Page 104

  • Download
  • Add to my manuals
  • Print
  • Page
    / 559
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 103
Mechanical Installation & Cabling MultiVOIP User Guide
104
Cabling Procedure for MVP210
Cabling involves connecting the MultiVOIP to your LAN and telephone
equipment.
1.
For DID channels only. If both channels of your MVP210 MultiVOIP
will be using either FXS, FXO, or E&M telephony interfaces, skip to
step 2.
For any channel on which you are using the DID interface type, you
must change the jumper on the MultiVOIP circuit card.
a. Disconnect power. Unplug the AC power cord from the wall outlet
or from the receptacle on the MultiVOIP unit.
b. Using a #1 Phillips driver, remove the screw (at bottom of unit,
near the back-cover end) that attaches the main circuit card to the
chassis of the MVP210.
c. Pull the main circuit card out about half way.
Page view 103
1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 558 559

Comments to this Manuals

No comments