Multitech MULTIVOIP MVP-810ST User's Guide download pdf (Page 259)

100

101

MultiVOIP User Guide Technical Configuration (Analog/BRI)

259

DID Parameters. The parameters applicable to the Direct Inward Dial

(DID) telephony interface type are shown in the figure below and

described in the table that follows. The DID interface allows one phone

line to direct incoming calls to any one of several extensions without a

switchboard operator. Of course, one DID line can handle only one call

at a time. The parameters described here pertain to the customer-

premises side of the DID connection (DID-DPO, dial-pulse originating);

the network side of the DID connection (DID-DPT, dial-pulse

terminating) is not supported.

DID Interface Parameter Definitions

*Not applicable to MVP130FXS

Field Name Values Description

Interface DID-DPO Enables the customer-premises

side of DID functionality

DID Options MultiVOIP’s use of DID applies

only for incoming DID calls.

The Start Mode used by the

MultiVOIP must match that

used by the originating

telephony equipment, else DID

calls cannot be completed.

Start Modes Immediate Start,

Wink Start,

Delay Dial

For Immediate Start, the voip

detects the off-hook condition

initiated by the telco central-

office call and becomes ready to

receive dial digits immediately.

1 2 ... 254 255 256 257 258 259 260 261 262 263 264 ... 558 559

Comments to this Manuals

No comments

Multitech MULTIVOIP MVP-810ST User's Guide Page 259

Comments to this Manuals

Related products and manuals for Networking Multitech MULTIVOIP MVP-810ST