Multitech MULTIVOIP MVP-810ST User's Guide download pdf (Page 78)

100

101

Quick Start Instructions MultiVOIP User Guide

Connectivity Test

The procedures “Phone/IP Starter Configuration” and “Phonebook

Starter Configuration” must be completed before you can do this

procedure.

1. These connections must be made:

Connections

for digital MultiVOIPs

(MVP-2410/3010)

for analog MultiVOIPs

(MVP-130/130FXS

& MVP-210/410/810)

MultiVOIP to local PBX MultiVOIP to local phone

station

–OR--

MultiVOIP to extension of

key phone system

MultiVOIP to command PC MultiVOIP to command PC

MultiVOIP to Internet MultiVOIP to Internet

2. Inbound Phonebook and Outbound Phonebook must both be set up

with at least one entry in each. These entries must allow for

connection between two voip units.

3. Console messages must be enabled. (If this has not been done

already, go, in the MultiVOIP GUI, to Configuration | Logs and

select the “Console Messages” checkbox.

4. You now need to free up the COM port connection (currently being

used by the MultiVOIP program) so that the HyperTerminal program

can use it. To do this, you can either (a) click on Connection in the

sidebar and select “Disconnect” from the drop-down box, or (b) close

down the MultiVOIP program altogether.

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 558 559

Comments to this Manuals

No comments

Multitech MULTIVOIP MVP-810ST User's Guide Page 78

Comments to this Manuals

Related products and manuals for Networking Multitech MULTIVOIP MVP-810ST