Multitech PROXYSERVER MTPSR1-120 User's Guide download pdf (Page 38)

Dual Ethernet ProxyServer User Guide

Enabling SLIP

If you wish to configure the port for use with SLIP, click on the Enable check box in the SLIP

group.

The following message appears:

Click OK. This value was assigned in the initial software installation and was downloaded to the

ProxyServer at the end of the installation. If you wish to verify or change the WAN IP address,

click on IP in the Firewall Setup menu.

If you wish to make use of CSLIP (Van Jacobsen Compression), click on the CSLIP (Van

Jacobsen Compression check box to enable CSLIP. Verify (or change) the Maximum Transmit

Unit value (for definition and parameters of a specific field, refer to the on-line help).

By default, Dial On Demand is enabled. If you do not wish to use this feature, click on the Enable

check box in the Dial On Demand group to disable it.

When you have finished the configuration, click OK. You are returned to the Firewall Setup

menu. Click Download Setup to save the new configuration to the ProxyServer.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 59 60

No comments

Multitech PROXYSERVER MTPSR1-120 User's Guide Page 38