Multitech MultiModem DSVD MT5600DSVD Instruction Manual download pdf (Page 32)

22 Using the SmartServer Service Buttons and LEDs

Using the SmartServer LEDs

The SmartServer has a number of LEDs that provide status information. The following figure and

table display and describes these LEDs.

Power/Wink

Lights when the SmartServer has power. When the SmartServer receives a

ONWORKS wink command, this LED blinks on and off 5 times. When the

SmartServer’s applications are not running, this LED blinks rapidly.

Service

Indicates the state of the LonTalk application in the SmartServer. This

LED is normally off. Blinking indicates the application is in the

unconfigured state. This LED will remain lit when the SmartServer is in

Security Access Mode.

Meter

The SmartServer has two Meter LEDs, which are labeled 1 and 2. The

Meter1 and Meter2 LEDs light when a pulse is received on the Meter1 and

Meter2 inputs, respectively.

Input

The SmartServer has two Input LEDs, which are labeled 1 and 2. The

Input 1 and Input 2 LEDs light when an ON value is received on the Digital

Input 1 and Digital Input 2 inputs, respectively.

The LEDs respond appropriately when the Invert option is selected. For

example, if an open circuit is interpreted as ON, then the LED will light

when the circuit is open and vice versa. The digital input requires a

minimum voltage differential of 3.4V.

Output

The SmartServer has two Output LEDs, which are labeled 1 and 2. The

Output 1 and Output 2 LEDs light when power is applied to the Digital

Output 1 and Digital Output 2 outputs, respectively. An Output LED lights

when the relay contacts are closed, and it is off when the relay contacts are

open.

LAN Link

Lights when an Ethernet connection has been established.

LAN ACT

Lights when there is activity on the Ethernet connection.

LAN 100

Lights when the Ethernet connection is operating at 100 Mbps. Note that

power line models operate at 10 Mbps.

LON Connect

Lights when the SmartServer is being used as a remote network interface

(RNI) or an IP-852 router.

1 2 ... 27 28 29 30 31 32 33 34 35

No comments

Multitech MultiModem DSVD MT5600DSVD Instruction Manual Page 32