Multitech BL-Series User Manual download pdf (Page 41)

Voice Commands for the MT5656ZDXV and MT5600ZDXV Modems

Multi-Tech Systems, Inc. Commands Reference Guide (PN S000273D)

+VSD Silence Detection (Quiet and Silence) Continued

<sdi> Decimal number specifying the required period of silence, in units of 0.1 second,

before the modem can report silence detected at the end of a voice receive either with

the “Presumed End of Message” (QUIT) or “Presumed Hangup (SILENCE) event

reports. A value of 0 disables the modem silence detection. The range is 0.1 to 25.5

seconds for <sdi> = 1 to 255.

Reporting Current or Selected Values:

Command: +VSD?

Response: <sds>,<sdi>

Example: 0,50 For the default setting.

Reporting Supported Range of Parameter Values:

Command: +VSD=?

Response: (<sds> range),(<sdi> range)

Example: (0,127-129),(0-255)

Result Codes: OK <hook> = 0 or 1.

ERROR Otherwise, or if not in Voice Mode.

Command: +VTD= Beep Tone Duration Timer

Description: This command causes the modem to set the default DTMF/tone generation duration.

Syntax: +VTD=<dur>

Defined Values: <dur> Decimal number specifying the default DTMF/tone generation duration in units of

0.01 second. A value of 0 specifies the value entered by the S11 parameter (50-255

ms). The range is 0.01 to 2.55 seconds for <dur> = 1 to 255.

Reporting Current or Selected Values:

Command: +VTD?

Response: <dur>

Example: 100 For the default setting.

Reporting Supported Range of Parameter Values:

Command: +VTD=?

Response: (<dur> range)

Example: (0-255)

Result Codes: OK <dur>= 0-255.

ERROR Otherwise, or if not in Voice Mode.

Command: +VDR= Distinctive Ring

Description: This command causes the modem to enable or disable reporting of the ring cadence

information and to control the timing of the RING event code report if ring cadence

reporting is enabled.

Syntax: +VDR=<enable>, <report>

Defined Values: <enable> Decimal number corresponding to the selected option.

0 The modem will not report ring cadence information.

1 The modem will report ring cadence information as specified for the

<report> subparameter.

<report> Decimal number specifying ring cadence information report when enabled by

the <enable> subparameter.

0 The modem will produce only DROF and DRON messages. The modem

will not produce any RING event codes. The modem will report other call

progress event codes as normal.

Other The modem will produce only DROF and DRON messages. The

modem will produce a RING event code after <report>/10 seconds after

the falling edge of the ring pulse (i.e., after the DRON report).

Reporting Current or Selected Values:

Command: +VDR? Response: <enable>,<report>

Example: 0,0 For the default setting.

Reporting Supported Range of Parameter Values:

Command: +VDR=? Response: (<enable> range),(<report>range)

Example: (0,1),(0-6)

Result Codes: OK <enable>,<report> = (0,1),(0-6)

ERROR Otherwise, or if not in Voice Mode.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 59 60

Comments to this Manuals

No comments

Multitech BL-Series User Manual Page 41

Comments to this Manuals

Related products and manuals for Networking Multitech BL-Series