Multitech RF760 User's Guide download pdf (Page 86)

Chapter 6 – RouteFinder Software

Multi-Tech Systems, Inc. RouteFinderVPN RF760/660/600VPN User Guide (PN S000323D) 86

Network Setup > PPP

The PPP link is used as a backup link to the WAN interface. If the PPPoE or static link goes down, the backup link will

automatically come up and the system will be again connected to the ISP. On this screen you can set up PPP dial up backup

for your WAN interface.

PPP Settings

Enable PPP Dial Backup for WAN – To enable PPP Dial Backup for WAN, check the corresponding checkbox.

Baud Rate – Select the baud rate from the drop down list box. Options: 9600, 19200, 38400, 57600, and 115200.

Serial Port – Select the Serial Port from the drop down list box. Options: COM1 and COM2; use COM2.

Initialization String – Enter the set of commands you want sent to the modem at startup. The initialization string

sets speed, error correction, compression, various timeout values, and how to display results to the user. You can

also change your country or region code by including the country/region code AT command in the initialization

string (see directions below).

Dial Number – Enter the phone number that the modem will use to connect to the PSTN.

User Name – Enter the ISP User Name designated for dialup access.

Password – Enter the ISP Password designated for dialup access; the password is optional.

Enable IP Setting – Check this box to enable the IP setting. This option can be set to make the firewall negotiate

for a particular IP address from the ISP.

Local IP Address – If the checkbox Enable IP is checked, the IP address has to be entered in this field.

Save – Click Save to activate these settings.

Change Your Country/Region Code

To change the country/region code, the initialization string must contain the AT command for your specific country

or region.

1. Type AT%T19,0,nn, where nn is the country/region code in hexadecimal notation.

Click Enter.

OK displays.

2. To verify that the correct country/region has been configured, type:

ATI9 and click Enter.

3. The country/region code displays:

Example: Country/Region AT Command (hexadecimal) Result code (decimal)

Euro/NAM AT%T19,0,34 (default) 52

A list of country/region codes can be found on the Multi-Tech Web site at

http://www.multitech.com/PRODUCTS/Categories/Modems/global/configuration.asp#chart

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 188 189

No comments

Multitech RF760 User's Guide Page 86