Multitech MT9234ZPX-UPCI User's Guide download pdf (Page 34)

Appendix C – Upgrading Modem Firmware

34 MultiModem ZPX UPCI/PCIe User Guide

Extracting the Upgrade Files

1. Click Firmware and then click the firmware upgrade link.

2. Click Open and then click Extract.

3. Select the folder where you installed the Flash Wizard and click Extract. The default folder is C:\Program

Files\Multi-Tech Systems\Flash Wizard.

4. Note the name of the new firmware.

Clearing Your Stored Parameters

Before you flash your modem, record the parameters that are currently stored in it, so you can reprogram it after

flashing. After you have recorded them, send the AT&F command to reset the modem to clear the stored -

parameters.

1. Run your favorite terminal program, such as HyperTerminal.

2. In the program’s terminal window, type AT&V and press Enter to list your modem’s current parameters.

3. Record your parameters by saving the screens and sending them to your printer.

4. Type AT&W1Z and press Enter to clear your stored parameters and reset your modem to factory default.

5. Close the terminal program.

Upgrading the Modem’s Firmware

Warning: Never install an older version of firmware over a newer version. This destroys the flash PROM! If the

flash PROM is destroyed, the modem must be sent in for repair.

1. Click Start | Programs | Flash Wizard to launch the Flash Wizard. The Identifying Devices dialog box is

displayed as Flash Wizard locates and identifies the devices connected to your system.

Note: If the message ERROR: No valid devices detected is displayed, verify that the modem is turned on

and that all cables are correctly and securely attached. Verify that the terminal application or

software application is turned off.

2. Select the modem to be upgraded, and then click Next.

3. Select the port to be upgraded and the appropriate .HEX file, and then click Next.

Note: Do not use FLASHLDR.HEX. This file is used internally by Flash Wizard.

Caution: If the upgrade is disrupted at this state, your modem may become inoperable. Wait for Next to

become active before proceeding.

Programming Complete appears and Next becomes active when the flash upgrade is complete.

4. Click Next to continue.

5. Click Finish to exit the Flash Wizard.

Restoring Your Parameters

Your modem has been upgraded. Open your terminal program to reprogram your modem parameters or to

confirm the upgrade by typing ATI in the terminal window and pressing Enter.

1 2 ... 29 30 31 32 33 34 35 36

No comments

Multitech MT9234ZPX-UPCI User's Guide Page 34