Multitech MT9234ZPX-UPCI User's Guide download pdf (Page 27)

Appendix B – Regulatory Compliance

MultiModem ZPX UPCI/PCIe User Guide 27

This equipment is not capable under all operating conditions of correct operating conditions of correct

operation at the higher speed which it is designated. 33.6 kbps and 56 kbps connections are likely to be

restricted to lower bit rates when connected to some PSTN implementations. Telecom will accept no

responsibility should difficulties arise in such circumstances.

2. Immediately disconnect this equipment should it become physically damaged, and arrange for its disposal or

repair.

3. This modem shall not be used in any manner which could constitute a nuisance to other Telecom customers.

4. This device is equipped with pulse dialing, while the Telecom standard is DTMF tone dialing. There is no

guarantee that Telecom lines will always continue to support pulse dialing.

Use of pulse dialing, when this equipment is connected to the same line as other equipment, may give rise to

'bell tinkle' or noise and may also cause a false answer condition. Should such problems occur, the user should

NOT contact the Telecom Faults Service.

The preferred method of dialing is to use DTMF tones, as this is faster than pulse (decadic) dialing and is

readily available on almost all New Zealand telephone exchanges.

5. Warning Notice: No '111' or other calls can be made from this device during a mains power failure.

6. This equipment may not provide for the effective hand-over of a call to another device connected to the same

line.

7. Some parameters required for compliance with Telecom’s Telepermit requirements are dependent on the

equipment (PC) associated with this device. The associated equipment shall be set to operate within the

following limits for compliance with Telecom’s Specifications:

For repeat calls to the same number:

● There shall be no more than 10 call attempts to the same number within any 30 minute period for any

single manual call initiation, and

● The equipment shall go on-hook for a period of not less than 30 seconds between the end of one

attempt and the beginning of the next attempt.

For automatic calls to different numbers:

● The equipment shall be set to ensure that automatic calls to different numbers are spaced such that

there is no less than 5 seconds between the end of one call attempt and the beginning of another.

8. For correct operation, total of the RN’s of all devices connected to a single line at any time should not exceed

Russian Statements

MT9234ZPX-UPCI is Russia approved, Declaration of Conformity # Д-ТФ-0607 valid till 25.01.2015 (for MT9234ZPX-UPCI).

MT9234ZPX-PCIE is Russia approved, Declaration of Conformity # Д-ТФ-0606 valid till 25.01.2015 (for MT9234ZPX-PCIE).

South African Statement

This modem must be used in conjunction with an approved surge protection device.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 35 36

No comments

Multitech MT9234ZPX-UPCI User's Guide Page 27