Multitech ISI552PC Owner's Manual

Browse online or download Owner's Manual for Unknown Multitech ISI552PC. Multitech ISI552PC Owner`s manual User Manual

  • Download
  • Add to my manuals
  • Print

Summary of Contents

Page 1 - Owner's Manual

Intelligent Serial Interface (ISI)Model ISI552PC CardOwner's ManualMultiTechSystems

Page 2

2-32.3 Hardware Installation ProcedurePerform the procedures in Table 2-1 to configureand install the ISI552PC card into your ISA or EISAbus

Page 3

2-4Table 2-1 (cont'd) Step ProcedureISI Configuration and Installation Procedure2 Remove the cover of yourcompu

Page 4 - 1 . 1 Introduction

2-54b Select a unique I/O Address foryour ISI552PC card using theblock of 8-position DIP-Switcheson your ISI circuit board. Figure2-3 (next pa

Page 5 - 1 . 2 Product Description

2-6 Table 2-1 (cont'd) ISI Configuration and Installation Procedure Step Procedure6 Install the ISI card int

Page 6

2-7 Step Procedure8 Connect the appropriate cable tothe ISI card. The ISI552PC hasone DB-9 connector. The DB-9is a DTE-type serial port

Page 7

3-13.1 IntroductionThis chapter starts out with statements about yourISI552PC's 10-year warranty. The next section,Tech Support, should be r

Page 8 - Settings

3-2MTSs entire obligation under this warranty shall belimited (at MTSs option) to repair or replacement ofany products which prove to be defective w

Page 9

3-33.3.1Recording ISI552PC InformationPlease fill in the following information on your Multi-Tech product. This will help tech support in answeringyou

Page 10

3-43.3.2 ServiceIf your tech support specialist decides that serviceis required, your unit may be sent (freight prepaid)to our factory. Return shipp

Page 11

3-5If you need to inquire about the status of thereturned product, be prepared to provide the serialnumber of the product sent (see Sectio

Page 12

Owner's ManualP/N 82033101, Rev. BISI552PCThis publication may not be reproduced, in whole or in part, withoutprior expressed written permission

Page 13

3-6Canada) or 612-785-3702 (International).3. At the prompt, type your first name, last name,password, then hit RETURN. If you are a first timecall

Page 14

3-73.5 About CompuServe/InternetIn addition to the BBS, Multi-Tech provides supportthrough CompuServe's Modem Vendor Forum(GOMODEMVEN) under

Page 15 - 3.2 Limited Warranty

3-83.6 About the Multi-Tech Fax-Back ServiceMulti-Tech's fax-back system provides 24-hour accessto sales, marketing, and technical literature.

Page 17

NOTE: This equipment has been tested and found to complywith the limits for a Class B digital device, pursuant to Part 15 ofthe FCC Rules. These limit

Page 18 - 3.3.2 Service

1July 12, 1995Product Updatefor ISI551PC & ISI552PC Cards#82048100This product update is a supplement to your ISI551PC and/or yourISI552PC Owner&a

Page 19 - 3.4 About the Multi-Tech BBS

1-IndexIndexAAbout CompuServe/Internet ... 3-7About the Multi-Tech BBS ... 3-5BBaud Rates ...

Page 20

2-IndexISI Card Installation ... 2-1LLimited Warranty ... 3-1MMulti-Tech BBS ...

Page 21 - 3.5 About CompuServe/Internet

MultiTechSystems82033100

Page 22 - Back Service

iTABLE OF CONTENTSCHAPTER 1INTRODUCTION & DESCRIPTION1.1 Introduction ... 1-11.2 Product Description ...

Page 23 - 82033101

1-11 . 1 IntroductionThe introduction of high speed, data compressionmodems, such as Multi-Tech's MultiModemII TMSeries, has shown

Page 24

1-2This manual contains product specification,installation instructions, configuration and technicalsupport information which will assist you

Page 25 - #82048100

1-3This manual includes hardware configuration andinstallation procedures described in Chapter 2. Chapter3 covers technical support, warrant

Page 26

1-4Card DimensionsISI552PC· 4.950" L x 4.2" W x .062" D· 12.573 cm L x 10.668 cm W x .16 cm DBaud Rates· Up to 115.2K bps per port (tw

Page 27

2-12.1 ISI Card InstallationThis chapter explains procedures for installing yourISI552PC card into your ISA or EISA bus personalcomputer (PC/XT/A

Page 28 - MultiTech

2-2addresses are also unused. (For example, if youuse the base I/O address of 380h, addresses 380h-387h must be unused.)To select an unused I/O addr

Comments to this Manuals

No comments