Multitech MT1932ZDXK User Manual Page 8

  • Download
  • Add to my manuals
  • Print
  • Page
    / 16
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 7
DS 2.501A 8 - 16 03/03
MIU COMMISSIONING (RS 232 TO RS 485 CONVERTER MODE)
1. Disconnect power supply.
2. Remove the gland plate and using a 25 way null modem cable
connect the MIU to the computer. Note the computer connector
may be a 9 way D type connector, either use a 9 to 25 way adapter
or a 9 to 25 way ribbon cable.
3. Select the mode of operation from bit switches 7 and 8.
Bit switch 7 ON (transparent operation).
Bit switch 8 ON (RS 232 operation).
4. Select the communication speed for both the PC and LAN by using
the jumpers (LK 6 and LK 5 respectively). The communication
speeds are marked on the PCB. It is possible to set the LAN
communication speed from a computer running Satchnet
Networking Software version 6.3 or later, if this is required jumper
LK 5 should be removed.
5. The RUN, MODEM and DUMB LED's should light simultaneously.
The MODEM LED will then go OFF.
6. If the start up sequence does not follow the description in
instruction 5 then turn the power off and check that the MIU and
controllers have been correctly wired and that there are no short
circuits in the communication wiring. Switch on the power and
check the MIU start up sequence again. If no obvious fault is found
and the MIU still fails to start correctly then the MIU should be
replaced.
7. The MIU is now fully operational.
MIU 3252 AS AN RS232 TO RS485 CONVERTER - SPEC 585-3-252
To further
controllers on the
LAN e.g. IAC400
600, CSMC, MMC
etc.
Standard
Null
Modem
Cable
RS232
Port
inside
MIU
LAN Port
Fig.9
WESTERMO MA-42 RS232 TO RS485 CONVERTER
Westermo Hardware Settings. See the
following text.
1. There are two types of MA-42 only
distinguishable by the fact that one
version uses surface mounted ICs.
To further controllers on the
LAN e.g. IAC400/600,
CSMC, MMC etc.
* Do not use Westermo User
Manual terminal numbers.
Line Connection
Fig.10
V24/RS232-C
Connection
Page view 7
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments