Multitech SF100-G-EU Specifications download pdf (Page 52)

Chapter 4 – Using the MultiModem iSMS Web Interface

MultiModem® iSMS System Administrator’s Guide 52

Non Polling Receive API Configuration

This group helps you select which method of Receive API is implemented by the MultiModem iSMS server (how SMS

Messages received from the cellular network are handled).There are two methods:

● Polling: the received SMS is left in the Receive SMS queue until your application queries for it using an HTTP GET.

● Non Polling: Upon reception, the MultiModem iSMS server POSTs the message to your WEB server (or TCP

application).

When the "Non Polling Receive API Status" checkbox is NOT checked, polling is enabled. When polling is enabled, perform

the query on the HTTP Port number defined in the HTTP API Configuration section/menu.

Non Polling Receive API Status

Check this box to enable non-polling API status when receiving messages. This changes the SMS API section as shown

below. When this is not checked, Receive API Polling is enabled. Receive API Polling is the default.

Protocol

Select the protocol that to use: HTTP or TCP.

Server

Enter the resolvable name or IP address of the server to use.

Port

Enter the port number for accessing the server.

Server Default Page

Enter the default page for the server to use.

Server Authentication

Check this box if you want to authenticate to the server. Below you can enter the username and password that allows

access.

Username

Enter the username used for authentication.

Password

Enter the password associated with the above username.

Post Interval

Enter the number of seconds for the post interval.

Save Buttons

Click Save for each section after making changes. Unsaved changes are not maintained when you navigate from this page.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 125 126

No comments

Multitech SF100-G-EU Specifications Page 52