Chapter 6 – Upgrading the Firmware and Flash
Multi-Tech Systems, Inc. Serial-to-Ethernet Device Server User Guide (S000344E) 18
Upgrading the Flash
Serial Flash Upgrade
The following steps explain the procedure to upgrade a flash using the serial COM port (serial flash upgrade).
Connect the Device Server to a PC COM Port.
• Open an application through which we can access the serial device(e.g., Meterm, zoc, hyperterm).
• Reboot the Device Server.
• Wait for the boot message and prompt “press d to download” to appear.
• Press d when prompted.
• Select the XMODEM Protocol from the Terminal application.
• Choose a file (MTXCSEM-TFTP-…) file to be uploaded.
• Perform a file upload.
The Device Server reboots and will be up after a few seconds (10-15 secs).
Ethernet Flash Upgrade
The Device Server can be remotely upgraded over a network. Make sure a TFTP client is already installed on
the machine.
The following steps explain the method to perform flash upgrade from Ethernet.
• Make sure the Device Server is reachable on the LAN.
• Perform a TFTP to the Device Server from a TFTP client.
– Set binary mode on (Note: This step is very important)
– Binary
• Put the binary file.
– put <binary filename>
• Exit the TFTP session.
– quit
The Device Server reboots after it has been successfully upgraded.
Comments to this Manuals