Multitech MTS2EA User's Guide download pdf (Page 12)

Chapter 3 – Managing and Configuring the MultiConnect

Multi-Tech Systems, Inc. Serial-to-Ethernet Device Server User Guide (S000344E) 12

Chapter 3 – Managing and

Configuring the MultiConnect

Two Ways to Login

• Use Telnet Client to configure the MultiConnect for the first time. Type the default IP address of the

MultiConnect: 192.168.2.1.

Note: The workstation must be on the same subnet.

• At the Login prompt, type admin.

At the Password prompt, type admin.

Important: User Name and Password are case-sensitive. They must be typed in lowercase letters.

Use a terminal program, such as HyperTerminal, to access the serial port.

• Use TTY to configure your MultiConnect for the first time. Configure the workstation’s serial port to

the defaults listed below:

Baud: 115.2K

Data: 8

Parity: N

Stop: 1

Flow-Control: None

• Press the Enter key three times to get to the Login prompt.

• At the Login prompt, type admin.

At the Password prompt, type admin.

Important: The User Name and Password are case-sensitive. They must be typed in lowercase

letters.

About Data Mode and Command Mode

• In Command Mode, a # sign designates the prompt. Help, at the command prompt, accesses a complete list

of commands supported.

• Usage, at the command prompt, provides the semantics of the commands.

• In Data Mode, the # sign is not displayed.

• To end Command Mode, exit your terminal or Telnet session or invoke Exit at the command prompt.

• See the Restore command and IP Escape String command.

Device Port

The RS-232 port.

Connects to the Host/Serial interface on the device.

Referred to as S0.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 20 21

No comments

Multitech MTS2EA User's Guide Page 12