Multitech MTCMR-E1 User's Guide download pdf (Page 12)

MultiModem rCell Intelligent Wireless Router

12 Multi-Tech Systems, Inc. Quick Start Guide

Network Registration Verification

Value Network Registration Status

+CREG: 0,0

The router is not registered on any network

+CREG: 0,1

The router is registered on the home network

+CREG: 0,5 The router is registered on a network and it is

roaming

Note: If the router indicates that it is not registered, verify the signal

strength to determine if the problem is the strength of the received

signal.

MTCBA-EV2-EN2 Note: Using a terminal program, sending the

command AT!STATUS will return several lines of information. The

second from the last response will either be “Modem has registered” or

“Modem has NOT registered”.

Verify Account Activation

Carrier account activation is verified by ensuring that your account with the

respective wireless network carrier is active and the automatic carrier

activation process has been successfully completed. To verify account

activation, perform the following general procedures.

1. Perform the appropriate carrier activation process for the carrier you

are connecting to. Refer to the Carrier Activation Notice supplied

with your router.

Powering Down/Hardware Resetting a MTCBA-C1-EN2 Router

It is recommended to follow the following shutdown sequence, when

possible, prior to a hardware reset or turning off of power to the router.

The shutdown sequence informs the network that the mobile station is

going offline, and saves critical data to the module‘s non-volatile

memory (flash).

AT+CFUN=0 (issue this command)

+WIND:10 (Wait for this response from the modem)

Router is now ready to be powered off or reset.

If you do not see the +WIND:10 response, you may need to activate

the unsolicited message by using the command

AT+WUSLMSK=00020000,0

1 2 ... 7 8 9 10 11 12 13 14 15 16

No comments

Multitech MTCMR-E1 User's Guide Page 12