Multitech CDMA User's Guide download pdf (Page 48)

Chapter 12 – No Prefix Commands

CDMA 1xEV-D0 AT Commands Reference Guide (Document S000482B) 48

M Mute (Speaker Control)

Syntax: ATM[n]

Description: This command is provided for compatibility reasons; the modem takes no action.

Parameters are ignored.

For control of voice mode microphone and speaker muting, see –MICMUT and -SPKMUT.

O Online (Remote)

Syntax: ATO

Description: Currently not supported.

Causes the modem to go from command state (online condition) to data state. The

modem responds with the normal CONNECT response codes (if enabled) as if the

connection were new.

This command is executed by the IWF modem. If the CDMA modem was in an offline

condition and without an airlink, the NO CARRIER and OK result codes are returned. If the

modem was offline and the airlink was established (pass through state) but without a call

in place, the IWF modem attempts to process the command. The typical result is either

NO ANSWER or NO CARRIER. This is, however, dependent on the IWF modem.

P Pulse Dialing

Syntax: ATP

Description: This command is provided for compatibility reasons; the modem takes no action.

Q Quiet (Result Code Display Option)

Syntax: ATQ[n]

Description: Controls the return or suppression of result codes to the host (DTE).

Value Setting

0 Disables Quiet mode (enables return of result codes.) Default.

1 Enables Quiet mode (disables return of result codes).

Result Codes:

OK n = 0

Otherwise the result code is suppressed (n=1).

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 66 67

No comments

Multitech CDMA User's Guide Page 48