Multitech CC4800 Owner's Manual download pdf (Page 12)

MR4800E Owner’s Manual

2.6 Quick Starts

2.6.1 MR4800E Quick Start

Follow the steps below to configure your MR4800E.

1. Power down your CC4800 rack.

2. Insert the MR4800E into your CC4800 rack.

3. Plug one end of the Ethernet cable in the Ethernet connector on the front of the MR4800E

and the other end in the Ethernet connector in the wall.

4. Run MultiExpress (or any data comm package) at 115,200 with no flow control. Connect the

COM Port associated with the data comm package to the RS-232 port on the back of the

CC4800 rack.

5. Turn the power on for the CC4800 rack and for the terminal. If the power is already on, press

the Reset Button on the MR4800E front panel with the end of a paper clip.

6. You should see a screen that says "Welcome to the MultiModemManager MR4800E" and a

DOS prompt.

7. At the userid prompt, type "supervisor"

8. At the password prompt, type "supervisor"

9. The message, "MultiModemManager MR4800E Environment setup" is displayed. You will be

prompted to enter the IP address of the MR4800E (i.e., IP address assigned to you by your

network administrator), default Trap IP address (i.e., IP address of the Supervisor), default

gateway IP address (i.e., IP address of the local router, if any), subnet mask, and community

strings.

10. You will be prompted to change the supervisor user id and password.

Reset the MR4800E by pressing the reset button on the front with a paper clip or power the

rack off and on.

Note: Do not hit a key to start manually. Allow the MR4800E to start automatically.

12. Every time after this, the MR4800E will start automatically when you power up the rack.

2.6.2 Supervisor Console Quick Start

1. On the supervisor console, install the MultiModemManager software (see

MultiModemManager Owner's Manual for more information).

2. Install the Newt TCP/IP package.

3. After the installation, run the MultiModemManager software.

4. Click on Setup | SNMP | Mode | Supervisor.

5. Click on the Yes button when you are asked if you are sure.

6. In the Modem Group window, click on the World icon.

7. Click on the Add button.

8. Type the IP address of the MR4800E (the same one you used in step 9 of the MR4800E

Quick Start).

9. Click on OK.

10. The IP will "turn green" indicating the supervisor console is able to communicate with the

remote MR4800E.

11. System configuration is done using the supervisor console as specified in Section 2.7.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 63 64

No comments

Multitech CC4800 Owner's Manual Page 12