Multitech MA3a User's Guide download pdf (Page 18)

MultiArray User Guide

Disk Drive Installation

Installing Drives in the 8-Bay Disk Drive Chassis

1 Open the front door on the rack.

Note: Although you can remove the front door for installation purposes, you must replace the

door prior to applying power to the unit.

2 Remove the two top front drive chassis mounting screws. See Figure 2-7.

3 Loosen, but do not remove, the two rear drive chassis mounting screws. See Figure 2-7.

Front Drive Chassis

Mounting Screw

Rear Drive Chassis

Mounting Screw

Figure 2-7. 8-Bay Drive Chassis Mounting Screws

4 Slide the chassis out the front of the MultiArray to the end of the slide travel.

5 If any disk drives are installed in the 8-bay disk drive chassis, remove the ribbon (data)

and power cables from the disk drives.

6 Remove the two rear chassis mounting screws and slide the chassis out the front of the

MultiArray.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 39 40

No comments

Models	Document Type
ME Control	User Manual Nortec ME Control User Manual, 76 pages
MLP RO pump station	User Manual Nortec MLP RO pump station User Manual, 12 pages
ME Control Installation	User Manual Nortec ME Control Installation User Manual, 48 pages
Air Humidification System BS	User Manual Nortec Air Humidification System BS User Manual, 30 pages
ME Direct Feed Installation	User Manual Nortec ME Direct Feed Installation User Manual, 48 pages

Multitech MA3a User's Guide Page 18