Multitech RF825-C-NX-AP User Manual download pdf (Page 29)

Chapter 2 – Behind NAT Setup Examples

Multi-Tech Systems, Inc. RF825 Series IPSec VPN Setup Examples – A Reference Guide (S000440B) 29

Step 2 – Packet Filters

1. Go to the Packet Filters screen to give the client at the other end of the VPN tunnel the

rights to access across the tunnel.

2. Click on From (Host/Networks) and select the remote WAN IP and remote LAN IP you are

allowing to access your network (you should already have the LAN Any Any Accept listed).

3. If you are not restricting the type of service, select Any for the To (Host/Network).

4. Click the Add button to add this Packet Filter rule.

Important Note: Do not

check the Status box. When adding a user-defined rule, leave the

Status box unchecked.

Step 3 -- VPN Setup

1. Go to the VPN > IPSec screen.

2. Click on the VPN Status check box to enable IPSec. Then click the Save button.

3. Select Add an IKE Connection by clicking the corresponding Add button.

1 2 ... 24 25 26 27 28 29 30 31 32 33

No comments

Multitech RF825-C-NX-AP User Manual Page 29