Multitech MTA128ST Owner's Manual Page 59
- Page / 117
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
59-IWay Hopper
AT Commands/S-Registers
S-Register: S52
Function: Auto-Protocol Detection
Unit: Decimal ASCII code
Range: 0 or 1
Default: 1
Description: S52 sets whether the mechanism for identifying V.110, V.120,
X.75, MLPPP, or SoftBond operation is enabled or disabled. This is applicable for
an ISDN data call; and once determined by the MTA128ST the protocol used by
means of the information conveyed by the SETUP message, then the indicated
protocol is activated. The default setting is 1, which enables the Auto-Protocol
Detection function.
S-Register: S53
Function: Maximum Frame Size (X.75)
Unit: Decimal ASCII code
Range: 0-2048
Default: 2048
Description: S53 sets the maximum size of data frames in X.75 mode. This
register can be configured to contain as many as 2048 characters per frame, and is
the MTA128STs default value
4.3 Result Codes
When the MTA128ST receives an AT command from the computer or terminal, it
attempts to execute the command, then sends a status message to the computer or
terminal that reports the result of the command. The MTA128ST provides you
with several of these response messages, or result codes, which can be displayed
on your monitor or intercepted and used by your communications software. Using
the V command, you can select whether the result codes are terse (numbers) or
verbose (words).
The MTA128STs result codes are listed in the following table. Note that the
speed of an ISDN channel is always either 56K bps or 64K bps. CONNECT mes-
sages indicate the speed of the connection between the MTA128ST and your com-
puter or terminal.
- Model MTA128ST 1
- Owner's Manual 2
- Contents 4
- Contents 5
- Contents 6
- Chapter 1--Introduction 7
- 1.2 Features 7
- 8-IWay Hopper 8
- 1.4 Technical Specifications 9
- Introduction/Description 10
- 10-IWay Hopper 10
- Chapter 2--Introduction 11
- 2.2 Safety Warnings 11
- 2.4 Connecting to Power 12
- 2.5 Configuring the MTA128ST 13
- 14-IWay Hopper 14
- Installation 14
- 2.7 LED Indicators 15
- 16-IWay Hopper 16
- 17-IWay Hopper 17
- Installation 17
- Chapter 3--Introduction 18
- 3.2 Before You Start 19
- 20-Iway Hopper 20
- Configuration Utilities 20
- Call Control Configuration 20
- 21-IWay Hopper 21
- Com Port Settings 21
- 22-Iway Hopper 22
- 23-IWay Hopper 23
- 24-Iway Hopper 24
- 25-IWay Hopper 25
- 3.4 ConfigMenu 26
- 27-IWay Hopper 27
- ConfigMenu Menus 27
- 28-Iway Hopper 28
- 3.6 AT Commands 29
- Chapter 4--Introduction 30
- 4.1.1 Entering AT Commands 30
- 31-IWay Hopper 31
- AT Commands/S-Registers 31
- Command Function Section 31
- 32-IWay Hopper 32
- 4.1.2 Command Implementation 33
- 34-IWay Hopper 34
- 35-IWay Hopper 35
- 36-IWay Hopper 36
- 37-IWay Hopper 37
- 38-IWay Hopper 38
- 39-IWay Hopper 39
- 40-IWay Hopper 40
- 41-IWay Hopper 41
- 42-IWay Hopper 42
- 43-IWay Hopper 43
- 44-IWay Hopper 44
- 45-IWay Hopper 45
- 46-IWay Hopper 46
- 47-IWay Hopper 47
- 48-IWay Hopper 48
- 49-IWay Hopper 49
- 50-IWay Hopper 50
- 4.1.5 Data Call Commands 51
- 52-IWay Hopper 52
- 53-IWay Hopper 53
- 4.2 S-Registers 54
- 55-IWay Hopper 55
- 56-IWay Hopper 56
- 57-IWay Hopper 57
- 58-IWay Hopper 58
- 4.3 Result Codes 59
- 60-IWay Hopper 60
- 4.4.1 Modes of Operation 61
- 4.4.2 Making a Call 61
- 62-IWay Hopper 62
- Dialing 62
- 4.4.3 Answering a Call 63
- 4.4.4 Hanging Up 64
- Chapter 5--Introduction 65
- 5.2 Troubleshooting 65
- 66-IWay Hopper 66
- Troubleshooting 66
- 67-IWay Hopper 67
- 68-IWay Hopper 68
- 69-IWay Hopper 69
- 70-IWay Hopper 70
- Data Is Being Lost 71
- Chapter 6--Introduction 72
- 6.2 Limited Warranty 72
- 6.3 Technical Support 73
- 6.3.2 Service 73
- 6.4 The Multi-Tech BBS 74
- 75-Iway Hopper 75
- 76-IWay Hopper 76
- 6.6 About CompuServe/Internet 77
- Quick Setup Factory Profiles 78
- Quick Setup Example 78
- 79-IWay Hopper 79
- Configuration Profiles 79
- 80-IWay Hopper 80
- 81-IWay Hopper 81
- 82-IWay Hopper 82
- 83-IWay Hopper 83
- MTA128ST/Revision D PC Board 84
- MTA128NT/Revision B PC Board 84
- Product Update 100
- 107-IWay Hopper 107
- Index 108
- 109-IWay Hopper 109
- 111-IWay Hopper 111
- 113-IWay Hopper 113
- 115-IWay Hopper 115
- 117-IWay Hopper 117
Related products and manuals for Modems Multitech MTA128ST
Modems Multitech MT9234MU-CDC Specifications
(31 pages)
(31 pages)
Modems Multitech MT9234ZPX-UPCI User's Guide
(61 pages)
(61 pages)
Modems Multitech MT5634ZBA User's Guide
(59 pages)
(59 pages)
Modems Multitech MT5634MU User's Guide
(67 pages)
(67 pages)
Modems Multitech MTCBA-C-IP-N12 User's Guide
(29 pages)
(29 pages)
Modems Multitech MT2834BLR Owner's Manual
(76 pages)
(76 pages)
Modems Multitech MT5634ZBA-USB User's Guide
(41 pages)
(41 pages)
Modems Multitech MT5634IND User's Guide
(28 pages)
(28 pages)
Modems Multitech MT5600ZDX User's Guide
(83 pages)
(83 pages)
Modems Multitech MTSGSM User's Guide
(42 pages)
(42 pages)
Modems Multitech MTCBA-E-EN User's Guide
(29 pages)
(29 pages)
Modems Multitech MTCBA-G-UF1 Specifications
(44 pages)
(44 pages)
Modems Multitech MT5600BR-V92 User's Guide
(29 pages)
(29 pages)
© 2020, manymanuals.com. All rights reserved. | 0.040 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals