Multitech MTPSR3-100 User's Guide download pdf (Page 47)

Chapter 5 - Client Setup

Configuring in Windows NT

Perform the following steps to set up your Windows NT workstation PC:

Note: All of the hardware and screen samples in this section are intended as examples only. Please

select options appropriate to your network.

1 Click Start | Settings | Control Panel and then double click on the Network icon.

The Network dialog appears.

2 Click on the Protocols tab.

3 A list of protocols currently present on your PC is displayed. Check the installed protocols. If

you find TCP/IP Protocol listed, proceed to step 4. If TCP/IP is not listed, you must install it

prior to proceeding. Refer to Installing TCP/IP (WinNT), at the end of this section.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 78 79

No comments

Multitech MTPSR3-100 User's Guide Page 47