Multitech MTPSR2-201 User's Guide download pdf (Page 10)

DSU ProxyServer Quick Start Guide

Cabling Procedure

Step Procedure

1. Connect one end of the power supply to a live AC outlet

and connect the other end to the ProxyServer as shown in

Figure 3. The power connector is a 6-pin circular DIN

connector.

2. Connect the ProxyServer to a PC by using the short RJ45

to DB25 (female) cable provided with your unit. Plug the

RJ45 end of the cable into the Command port of the

ProxyServer and the other end into the RS232 cable from

the PC serial port. See Figure 3.

3. Connect a network cable to the ETHERNET 10BASET

connector on the back of the ProxyServer. Connect the

other end of the cable to your network.

4. Connect one end of the RJ48 cable to the 56K DSU

connector on the back of the ProxyServer. Connect the

other end to your DDS WAN connection.

5. If you wish to use the optional RS232 port for dial back-up,

connect one end of an RS232 cable to the RS232/V.35

connector on the back of the ProxyServer and connect the

other end of the cable to an external DCE device such as

a modem or T1 CSU.

5. Turn on power to the ProxyServer by placing the ON/OFF

switch on the back panel to the ON position. Wait for the

FAIL LED on the ProxyServer to go OFF before

proceeding. This may take a couple of minutes to go OFF.

At this time your ProxyServer is completely cabled. Proceed

to the next section to load the ProxyServer software.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17 18

No comments

Multitech MTPSR2-201 User's Guide Page 10