Multitech MVPFXS-24 User's Guide Page 33
- Page / 165
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
MultiVOIP FXS Quick Start Guide Phonebook Tips
33
3.
Knowing When to Drop Digits. Example
When calling area codes and
access codes are used in
combination, a leading “1” or “0”
must sometimes be dropped.
Phonebook Entry
Area code for Inner London is
listed as “0207.” However, in
international calls the leading
“0” is dropped.
International
Access Code
U.K.
Country
Code
Leading Zero
Dropped from
Area Code
4.
Using a Comma. Detail
, = 1-second pause
Commas are used in telephone
dialing strings to indicate a pause
to allow a dial tone to appear
(common on PBX and key
systems). Commas may be used
only in the “Add Prefix” field of
the Inbound Phonebook.
in many PBX systems
(not needed in all)
5.
Ease of Use. The phonebook setup determines how easy the voip system is to use. Generally, you’ll
want to make it so dialing a voip call is very similar to dialing any other number (on the PSTN or through
the PBX).
6.
Avoid Unintentional Calls to Official/Emergency Numbers. Dialing a voip call will typically be somewhat
different than ordinary dialing. Because of this, it’s possible to set up situations, quite unwittingly, where
phone users may be predisposed to call official numbers without intending to do so. Conversely, a
voip/PBX system might also make it difficult to place an official/emergency call when one intends to do so.
Study your phonebook setup and do some test-dialing on the system to avoid these pitfalls.
7.
Inbound/Outbound Pattern Matching. In general, the Inbound Phonebook entries of the local voip unit will
match the Outbound Phonebook entries of the remote voip unit. Similarly, the Outbound Phonebook
entries of the local voip unit will match the Inbound Phonebook entries of the remote voip unit. There will
often be non-matching entries, but it’s nonetheless useful to notice the matching between the phonebooks.
8.
Simulating Network in-lab/on-benchtop. One common method of configuring a voip network is to set up a
local IP network in a lab, connect voip units to it, and perhaps have phones connected on channel banks to
make test calls.
- MultiVOIP FX 1
- User Guide 2
- CONTENTS 3
- Chapter 1: Overview 5
- About This Manual 6
- (MVPFXS-8/16/24) 7
- MultiVOIP Front Panel LEDs 10
- Powe r Bo ot 10
- LNK FDX SPD COL 10
- 123 456789101112131415161718 10
- Computer Requirements 11
- Specifications 11
- Installation at a Glance 12
- Related Documentation 12
- Chapter 2: Quick Start Guide 13
- MultiVOIP Startup Tasks 14
- Gather IP Information 15
- Gather Telephone Information 15
- Placement 17
- Outbound Phonebook 27
- Answer: enter 8 in “Remove 29
- Answer: enter 9 in “Remove 29
- Inbound Phonebook 30
- Phonebook Tips 32
- , = 1-second pause 33
- Hilzenvalies, WV 34
- Telco Office of 34
- WVIP-Comm, Inc 34
- Bluebird Apartments 34
- Sample Phonebooks Enlarged 35
- Phonebook Worksheet 36
- Enlarged Phonebook Worksheet 37
- Connectivity Test 38
- Troubleshooting 40
- General Safety 42
- Lithium Battery Caution 42
- Ethernet (WAN) Ports Caution 42
- Safety Warnings Telecom 42
- Unpacking the MVPFXS-8/16/24 43
- Voip’s Default IP 47
- = 192.168.2.1 47
- Control Computer’s IP 47
- = 192.168. 2. x 47
- Summary 52
- Configuring the MultiVOIP 54
- Pre-Requisites 55
- IP Network Parameters: 55
- Record for each VOIP Site 55
- Record for this VOIP Site 56
- Default = disabled 61
- Default = enabled 61
- MultiVOIP gateways 65
- FXS Options fields 69
- Flash Detection Range fields 69
- Min. and Max., 50 69
- Caller ID fields 70
- Dialing Options fields 70
- Display shows: 71
- Coder Types Range (in ms); 82
- {default value} 82
- Increments (in ms) 82
- Values: Y/N 91
- 2 Site Example 93
- MVPFXS-24 94
- EXAMPLE: 98
- Digital & Analog VOIPs 98
- (hunting) 100
- Call Completion Summaries 103
- Site D calling Site F 104
- Site D calling Site E 105
- Site F calling Site D 105
- System Information screen 108
- Statistics Screens 111
- About Call Progress 111
- About IP Statistics 114
- Change Username/Password 117
- Save & Apply 119
- Reboot Voip 120
- Restore Factory Defaults 120
- Introduction 121
- Obtaining Updated Firmware 122
- C:\Acme-Inc\MVP3000-firm 124
- SysLog Server Functions 144
- Limited Warranty 147
- Contacting Technical Support 148
- Industry Canada 150
- FCC Part 68 Telecom 150
- Canadian Limitations Notice 151
- WEEE Statement 152
- Appendix A: Cable Pinouts 153
- Command Cable 154
- Ethernet Connector 154
- RJ-21 Connector 155
- Well-Known Port Numbers 157
- S000415A 165
Related products and manuals for Gateways/controllers Multitech MVPFXS-24
(4 pages)© 2020, manymanuals.com. All rights reserved. | 0.133 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals