Multitech MVPFXS-24 User's Guide download pdf (Page 7)

MultiVOIP MVPFXS-8/16/24 Cabling Guide

Multi-Tech Systems, Inc. 7

Pin-Out Information for 50-pin Connector

6. Console Connection (optional – not usually needed for initial setup). The

Console Cable is needed at initial setup only if your system cannot use the

voip’s default IP address. In that case, the Console Cable is used to change

the MultiVOIP’s IP address. Also, if, at a later date, you need to update the

MultiVOIP’s firmware, you will need to connect the Console Cable because it

is required for that process, as well.

If needed, connect the Console Cable (RJ45 male to DB9 female) between

the MultiVOIP and the control PC. Plug the RJ-45 end of the cable into the

CONSOLE port of the MultiVOIP and the DB-9 end into a serial port on

the PC.

7. Power-Up. Turn on power to the MultiVOIP by placing the ON/OFF switch

on the back panel to the ON position. Wait for the Boot LED on the

MultiVOIP to go off before proceeding. This may take a few minutes.

Proceed to the chapter “MultiVOIP and Auxiliary Software” in the User Guide.

That chapter describes how the built-in MultiVOIP software (firmware) is

accessed using a web browser and a Java program that are both up-to-date.

Best Case. If the Java and browser requirements have already been met,

and if you were able to assign the control computer to 192.168.2.x, then you

can make contact with the MultiVOIP immediately by surfing to 192.168.2.1

on the control computer.

VOIP Configuration

When the cabling connections above have been made and the command PC

has been equipped with an up-to-date web browser and Java version, then

you are ready to contact the MultiVOIP through a browser and begin

configuration. For detailed instructions about configuration, see the User

Guide on your MultiVOIP CD. The “Quick Start Guide” chapter of the User

Guide is the best place to start.

1 2 3 4 5 6 7 8

No comments

Multitech MVPFXS-24 User's Guide Page 7