Multitech RF650VPN User Manual download pdf (Page 8)

FriendlyNET VPN Security Router

The TCP/IP configuration of your computer is now complete. Re-

peat steps 1 – 4 and 7 – 10 to configure additional PCs on your net-

work.

Red Hat Linux

In order to gather the information necessary to complete the table,

you will need to run the /sbin/ipconfig command. You will also

need to examine the following files:

•

/etc/sysconfig/network

•

/etc/resolv.conf.

Please refer to your Linux documentation for information on access-

ing these files.

2. Install The Hardware

Follow these steps to connect the router to your network:

1. Turn the power off to your computers, modem and the router.

2. Connect an Ethernet cable from your Cable/DSL modem to the

router’s WAN port.

3. Connect an Ethernet cable from your computer’s Ethernet port

to one of the LAN ports on the router. Repeat the process to

connect other computers to the router. If you have more com-

puters to add than you have router ports, simply add a hub or

switch to one of the router ports. This creates additional avail-

able ports.

4. Optional: Use a DB-9 to DB-25 serial cable to connect a

straight through modem cable from your external backup mo-

dem to the router’s COM port.

5. Turn on the power to the router FIRST, and let it power up. The

router will enter a self-test mode where the status light will blink

for a few seconds and then stop. The router is ready for opera-

tion. Now you may turn on the power to the devices that are

attached to the router.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 75 76

No comments

Multitech RF650VPN User Manual Page 8