Multitech MultiModem DSVD MT5600DSVD Instruction Manual Page 17

  • Download
  • Add to my manuals
  • Print
  • Page
    / 35
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 16
i.LON SmartServer 2.0 Hardware Guide 7
!
Safety Warning
The SmartServer uses a Poly-carbonmonoflouride Lithium Coin battery. RISK OF
EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF UNUSED BATTERIES ACCORDING TO THE INSTRUCTIONS.
!
Safety Warning
The SmartServer is not equipped with a power disconnect device. When the device is
installed and mounted, the installer must provide a means to safely remove power, such
as a power switch or a circuit breaker.
!
Safety Warning
The high-voltage terminal block has a plastic cover protecting the screw terminals used to
connect the high-voltage inputs. This cover MUST be replaced after the power wires are
connected and before the power is activated.
The SmartServer is powered by a 100/240VAC, -6% to +10%, 50/60Hz VAC power mains
connection. This connection is also used for L
ONWORKS network communication for the PL-20
models of the SmartServer. The SmartServer contains an auto-ranging, auto-setting mains power
supply. You do not need to adjust any jumpers or other settings when connecting the SmartServer to
the AC power mains.
The high-voltage connection is implemented on screw terminals 1 (Earth Ground), 3 (Neutral), and 4
(Line). Screw terminal 2 (NC) is not used, and it should remain unconnected. A solid earth ground via
the terminal 1 connection is required for proper ESD and EMC performance of the SmartServer
device. You connect the screw terminals for the high-voltage models of the SmartServer in the
following order:
1. Insert the earth ground connection.
2. Insert the neutral connection.
3. Insert the line connection.
DO NOT apply power to the SmartServer until you have checked all wiring connections and you
are instructed to apply power.
The following figure illustrates the location of the high-voltage AC power mains screw terminals on
the SmartServer.
Page view 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 34 35

Comments to this Manuals

No comments