CHAPTER 5 – APPLICATION NOTES
SocketModem EV-DO MTSMC-EV3 Device Guide
Chapter 5 – Application Notes
LED Interface
The LED signal indicates the SocketModem working status. Refer to the mechanical drawing for LED locations.
LED 1 – Heartbeat – IP and –GP Builds Only
LED 2 – Link Status – All Builds
During initial connection to tower or when connected and
passing data.
Registered to tower and idle.
Powered not registered/Searching for registration.
N Note:
For non-IP builds, to ensure that the Link Status LED works properly, issue the following AT Command
sequence to the GPIO:
AT#GPIO=1,0,2
AT#SLED=2
LED 3 – Signal Strength –IP and –GP Builds Only
The faster the LED blinks, the stronger the signal. The blink rate range is -0.5Hz to -10Hz.
LED 4 – GPS Status – GP Builds
Comments to this Manuals