Multitech MTCMR-H User's Guide download pdf (Page 93)

Chapter 3 – Supported GSM/WCDMA AT Commands

High Speed HSPA-H4 AT Commands Reference Guide (Document S000483A) 93

0 Default. Subscribed value.

10...150 (value needs to be divisible by 10 without remainder)

200...950 (value needs to be divisible by 50 without remainder)

1000...4000 (value needs to be divisible by 100 without remainder)

This parameter specifies the relative importance for handling of all SDUs belonging

to the UMTS bearer compared to the SDUs of the other bearers.

0 Default. subscribed

<PDP_type>

Packet Data Protocol Type

“IP“ Internet Protocol (IETF STD 5)

Note: All QOS settings will be stored non volatile.

+CGEQREQ 3G Quality of Service Profile (Requested)

Description: The test command returns values supported as a compound value.

The read command returns the current settings for each defined context for which QOS

was explicitly specified.

The write command allows the TE to specify a Quality of Service Profile for the context

identified by the (local) context identification parameter <cid> which is used when the

MT sends an Activate PDP Context Request message to the network.

A special form of the write command, AT+CGEQREQ=<cid> causes the requested

profile for context number <cid> to become undefined.

Syntax:

Test Command: AT+CGEQREQ=?

Test Response: +CGEQREQ : <PDP_type>, (list of supported <Traffic class>s), (list of supported

<Maximum bitrate UL>s), (list of supported <Maximum bitrate DL>s), (list of supported

<Guaranteed bitrate UL>s), (list of supported <Guaranteed bitrate DL>s), (list of

supported <Delivery order>s), (list of supported <Maximum SDU size>s), (list of

supported <SDU error ratio>s), (list of supported <Residual bit error ratio>s), (list of

supported <Delivery of erroneous SDUs>s), (list of supported <Transfer delay>s), (list of

supported <Traffic handling priority>s)

Read Command: AT+CGEQREQ?

Read Response: +CGEQREQ: [<cid>, <Traffic class>, <Maximum bitrate UL>, <Maximum bitrate DL>,

<Guaranteed bitrate UL>, <Guaranteed bitrate DL>, <Delivery order>, <Maximum SDU

size>, <SDU error ratio>, <Residual bit error ratio>, <Delivery of erroneous SDUs>,

<Transfer delay>, <Traffic handling priority>]

[+CGEQREQ: <cid>, <Traffic class>, <Maximum bitrate UL>, <Maximum bitrate DL>,

<Guaranteed bitrate UL>, <Guaranteed bitrate DL>, <Delivery order>, <Maximum SDU

size>, <SDU error ratio>, <Residual bit error ratio>, <Delivery of erroneous SDUs>,

<Transfer delay>, <Traffic handling priority>]

[+CGEQREQ: ...]

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 146 147

No comments

Multitech MTCMR-H User's Guide Page 93