Multitech MTCMR-H User's Guide download pdf (Page 9)

Chapter 1– Introduction

High Speed HSPA-H4 AT Commands Reference Guide (Document S000483A) 9

Continued: Modem Status Commands, Customization, and Reset Commands

Command Description

!SMSSTSEN Enable/disable SMS status reports

!SWICALLPROG Enable/disable Call Progress Notification

^SYSCONFIG Set/return system configuration information

^SYSINFO Return service status information

!TIME Set/return current time of day

!UDINFO Return information from active USB descriptor

+UPSC Return Primary Scrambling Code (WCDMA only)

+USET Return WCDMA set information

&V Return Operating Mode AT Configuration Parameters

Diagnostic Command

This command is described in Chapter 2. It is used to select frequency bands and diagnose

problems.

Command Description

!MXSTATS

Display / clear 27.010 statistics

SIM Commands

These commands are described in Chapter 2. They communicate with an installed (U)SIM.

Command Description

!AUTH

Run GSM algorithm on SIM

!ICCID

Return (U)SIM card’s ICCID

!SPN

Return (U)SIM card’s SPN

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 146 147

No comments

Multitech MTCMR-H User's Guide Page 9