Multitech MTCMR-H User's Guide Page 11

  • Download
  • Add to my manuals
  • Print
  • Page
    / 147
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 10
Chapter 1– Introduction
High Speed HSPA-H4 AT Commands Reference Guide (Document S000483A) 11
Continued: ITU-T Recommendation V.250 AT Commands
Q
Set Result code presentation mode No
S0
Set number of rings before automatically answering the call Yes
S10
Set disconnect delay after indicating the absence of data carrier Yes
S3
Set command line termination character Yes
S4
Set response formatting character Yes
S5
Set command line editing character Yes
S6
Set pause before blind dialing Yes
S7
Set number of seconds to wait for connection completion Yes
S8
Set number of seconds to wait when comma dial modifier used Yes
T
Select tone dialing Yes
V
Set result code format mode Yes
X
Set connect result code format and call monitoring Yes
Z
Set all current parameters to user-defined profile Yes
ITU-T Recommendation 27.005 AT Commands
These commands are described in Chapter 3.
Command Description Supported
+CBM
Cell broadcast message directly displayed Yes
+CBMI
Cell broadcast message stored in memory at specified <index>
location
No
+CDS
SMS status report after sending a SMS Yes
+CDSI
Incoming SMS status report Yes
+CMGC
Send command Yes
+CMGD
Delete message Yes
+CMGF
Message format Yes
+CMGL
List messages Yes
+CMGR
Read message Yes
+CMGS
Send message Yes
+CMGW
Write message to memory Yes
+CMMS
More messages to send Yes
+CMNA
New message acknowledgement to ME/TA Yes
+CMS ERROR:
<err>
SMS error (mobile or network error) Yes
+CMSS
Send message from storage Yes
+CMT
Incoming message directly displayed Yes
+CMTI
Incoming message stored in <mem> (“SM” - (U)SIM message
storage) at location <index>
Yes
+CNMA
New message acknowledgement to mobile equipment Yes
+CNMI
New message indications to TE Yes
+CPMS
Preferred message storage Yes
+CRES
Restore settings No
+CSAS
Save settings No
+CSCA
Service center address Yes
+CSCB
Select cell broadcast message types Yes
+CSDH
Show text mode parameters Yes
+CSMP
Set text mode parameters Yes
+CSMS
Select message service Yes
Page view 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 146 147

Comments to this Manuals

No comments